Lowbed

Fliegl DTS 300

Chassis
Steel welded construction
Turntable with robust ball bearing race
Foldable rear support
2 support wedges with holder
Aluminum side impact protection
Splash guards at the rear across the entire width
Partial wheel arches on the 1st axle with anti-spray flaps, anti-spray flaps behind the 2nd and 3rd axles
1 plastic toolbox, with insert tray, w=620/h=360/d=440 mm, lockable with a padlock.
Extendable widening elements to 3,000 mm (not in rear slope)
Storage compartment for wooden planks in the middle of the loading area
Wooden planks 70 mm for widening to 3000 mm
Tie-down points for low-bed trailers
1 pair of recessed ring tie-down points at the front on the drawbar, each 5 tons
7 pairs of recessed tie-down loops on the top and sides of the outer frame, each 10 tons
1 x at the front on the drawbar
6 x in the low-bed area
First tie-down point 250 mm from the front and last tie-down point max. 250 mm from the rear, distance between tie-down points not greater than 1100 mm
5 pairs of recessed beam pockets in the outer frame, interior 70 x 40 mm (can be converted to 5-ton ring tie-down points, not included in the scope of delivery)
2 pairs of folding tie-down points in addition, each 10 tons
1 x on the drawbar (projects)
1 x behind the last axle, recessed in the floor
Coupling device, trailer turntable
Drawbar with tested 40 mm drawbar eye
Axles + Suspension
SAF drum brake axles
Axle/chassis laser-aligned to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical axle load compensation (rocker arm compensation)
Wheels & Tires
235/75R17.5 according to manufacturer's choice with M&S marking
Steel rims in twin arrangement, factory silver
Braking system
2-line compressed air braking system
Spring brake parking brake
2 non-interchangeable coupling heads at the front, with connecting lines to the towing vehicle
ABS and ALB, with ABS plug at the front, with connecting cable
Manufacturer: Wabco or Knorr
Note: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red marker lights at the rear
2 x 7-pin non-interchangeable plugs at the front, with connecting cable
1 LED rotating beacon with holder, switched via parking lights (light can be removed)
2 pairs of warning boards, double LED illuminated and extendable to 3,000 mm
Floor
Drawbar at the front with steel/diamond plate surface
Storage box in the ramp slope recessed into the drawbar
followed by 70 mm softwood floor, steel/diamond plate surface in the wheel arch area
Rear slope with 70 mm softwood floor
Low-bed area including rear slope 6,500 mm
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally adjustable
additional ramp securing device, foldable at the bottom (to prevent lateral slippage of the ramps, not in conjunction with lateral hydraulic ramp adjustment)
covered with wood
with spring-loaded support
Operating instructions
With an axle load of 10,000 kg, a special permit is required; only indivisible loads are permitted!!!
The specified total weight is technically possible; depending on the cargo, the total weight may not be reached while complying with the permissible axle/support and fifth-wheel loads.
Country of registration/plates
Rsdpfoi Riwfsx Ah Isw
Country of registration: Germany
Type approval according to EC 2007/46
24/7 service hotline

Огласот е автоматски преведен. Можно е да има грешки во преводот.