Semi-trailer containerchassis

Fliegl SDS 380 Gooseneck starr 40 light

Customized Transport Solution
Configure your Fliegl vehicle to meet your specific requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

Chassis for semi-trailer containers
Fine-grained steel welded construction, semi-trailer plate with replaceable kingpins
Container mounts: 1 x 40-foot with gooseneck tunnel
Transport of filled tank containers is not permitted.
Without rear height adjustment and without foldable center supports, transport of containers without a tunnel is not possible.
Front container guide, plug-in type
24-ton, 2-speed support jack, single-sided operation, with straight lower section, without thrust compensation
Fgjdji Ri Ayopfx Acwod
Wheel chocks with holders
Aluminum side impact protection
Galvanized steel underrun protection
Half-shell fenders
With anti-spray flaps per EC
Rear bumper
Axles + Suspension
SAF disc brake axles with 430 mm disc diameter
Axle/chassis laser-measured to reduce tire wear and fuel consumption
Offset wheelbase mm (combined transport) up to 44-ton gross train weight
Air suspension
1st axle: automatic lift axle, including forced lowering and start-up assist, operated by 3 brakes (start-up assist is functional up to a 30% axle load exceedance and up to a maximum speed of 25 km/h)
Brake system
2-line air brake system; color-coded lines for easy servicing.
Spring-loaded parking brake
EBS, Electronic Braking System with front EBS socket, without connecting cable
Warning: The trailer may only be towed by vehicles that ensure the effectiveness of the ABS!
With lift & lower valve
Vehicle stability control system
Axle load detection via EBS CAN bus signal, for display in the cab; truck must be equipped accordingly; no truck installation required.
Wheels and tires
385/55 R22.5, brand selected by the manufacturer
Steel rims, factory silver
Electrical System
24 volts, multi-chamber lights, LED taillights and brake lights, yellow LED side lighting
2 white front position lights
2 white/red rear lane-marking lights
1 x 15-pin socket at the front, without connecting cable
LED work lights on both sides (activated via reverse light)
Additional LED work light(s) at the rear, activated via reverse light
Operating Instructions
The specified gross weight is technically possible; however, depending on the load, the gross weight may not be achieved while complying with the permissible axle, support, and fifth-wheel loads
Special permit required if the total train length exceeds 16,500 mm
Caution: Transport of filled tank containers is prohibited!
Country of registration/plates
Germany
With DEKRA approval and certificate (per §13 EC - FGV)
Prepared for single-line license plate holder
Warning sign per ECE - 70
Contour marking with reflective strips per ECE R 048, white on the sides and red at the rear
Paint finish
Frame DB 7350 Novagrau
*10-year warranty against rust-through*
or hot-dip galvanized
*15-year warranty against rust-through*
Support legs black coated

Customized transport solution
Configure your Fliegl vehicle to meet your requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.