Baler 50 t, 22 kw drive power, with ruffler

Presona LP 50 EH1

Technical data baler:
Manufacturer Presona AB
Type LP 50 EH1
Year of construction 2005
Operating hours 30,408 hours, as of April
Number of pressed bales 198,059 as of April
Pressing force main press 50 tonnes
Specific pressing force 63 N/cm²
Theoretical throughput capacity 530 m³/hour
Throughput capacity under operating conditions 260 m³/hour
Dimensions of feed chute 1,250 x 1,100 mm
Bale chamber volume 2.2 m³
Bale dimensions 1,100 x 720 mm, variable length
Drive power 22 kW
Tying 5-fold vertical, fully automatic
Throughput rates with a
bulk density of 30 kg/cbm 6 up to 7 tonnes/hour
Bulk weight of 50 kg/cbm 7 up to 9 tonnes/hour
Bulk weight of 100 kg/cbm 11 up to 14 tonnes/hour
Bale density (paper/newspapers) 400 to 550 kg/m³
Hydraulic oil tank capacity 600 litres
Godpfxsy R Npij Ahasit
PLC control Telemecanique TSX Micro
Schneider Magelis control panel
Effective transport dimensions excl. baler 8,125 x 2,300 x 3,000 mm (L x W x H)
Transport weight press approx. 16 tonnes

Condition of the baler:
The machine was partial overhauled in our workshop and general maintenance work was carried out. After completion of the overhaul work, the press was tested during operation and is available for sale at short notice.

The following overhaul work was carried out:
General work:
Machine cleaned, derusted, primed, partially painted
Wire entry marks in the press channel feed-throughs welded shut and smoothed

Hydraulic unit:
Hydraulic oil tank emptied, tank cleaned, new oil filled
Oil filter and air filter replaced
Leaky oil sight glass on hydraulic oil tank replaced
All hydraulic hoses replaced

Electrics:
English language installed in the programme menu
Two key switches in the control panel replaced
Control cabinet replaced
Signal lamp on the control cabinet replaced
Flaps end switch replaced
Electrical system of the whirling unit replaced, connected and tested

Press ram:
All four rollers removed from the press ram and replaced
Main hydraulic cylinder dismantled, disassembled and partially overhauled, cylinder tube honed, complete seal set replaced, leak test performed
All plastic wear pads on the press ram replaced

Pre-press:
Both bearings on the pre-press shaft replaced.
Both hydraulic cylinders dismantled, disassembled and partially overhauled, both cylinder tubes honed, complete seal sets replaced, leak test performed.
Scraper flap on the pre-press replaced.

Binding system:
Two complete needles with wire deflection rollers replaced
Needles adjusted and set
All wire deflection rollers in the needle heads replaced
Drill fingers replaced
Two drill shafts replaced
All 8 wear plates on the Drillomat, under the drill fingers, replaced

Scope of delivery:
Only the baler will be sold.

The documentation (Manual, CE-declaration, electr./hydr.-drawings), are completely available. Inspections are possible after agreement. We will not assume liability for the given technical data and possible errors.