Industrial welding machine

Magmaweld ID500 ECO WELDING SYSTEM

Operates with 3 Phase 400V-50/60 Hz mains voltage and generators, tolerates voltage fluctuations up to 15%.
Due to inverter technology, energy efficiency is higher than the conventional machines.
Excellent welding characteristics with all types of solid and flux cored wires with CO2 or Mix gases.
4 Wheel Drive system, offers very powerful feedability for longer torches and offers less deformation on soft wires such as aluminum and flux cored wires.
Welding voltage, wire feed speed (welding current) is adjusted from the panel in front of the wire feeder.
Optimum welding parameters can be obtained from the printed table inside of the wire feed cabinet.
Manual wire feeding & gas valve buttons, Trigger Mode (2/4), Spot mode are available on the wire feeder.
Soft Start, Pre-gas, Post-gas, Crater Filling, Burn-Back, Flow Sensor settings are adjusted from the digital panel of the wire feeding system.
Fedjyx Hpiepfx Ac Dega
ø300 mm, ø270 mm and ø200 mm spools and drums of any size can be used.
24V AC outlet for CO2 gas heater.
Built in gas cylinder platform with large wheels to ease mobility in workshops.
The Separate wire feeder standard harness length is 5 m and can be extended up to 30 m upon request (M-MW models).
Protected against voltage fluctuations.
Designed also for outdoor use, protection class is IP 23.
Water cooling unit for water cooled torches provides powerful cooling even at very hot climates. (Water-cooled (W) models)
Standard accessories come with the machine.